SDC315 Multi-angle Band Saw Machine
Features
1. Suitable for cutting pipes according to specified angel and dimension while making an elbow, tee or cross, which lowest the material waste and improve the welding efficiency.
2. Cut pipe in any angle from 0-45°, can expand to 67.5°.
3. Automatic check band saw broken and stop machine to ensure operators safety.
4. Strong construction, easy operation, stable performance and low noise.
5. Reliability, lower noisy, easy to handle.
Specifications
| 1 | Equipment name and model | SDC315 Multi-angle Band Saw Machine |
| 2 | Cutting tube diameter | ≤315mm |
| 3 | Cutting angle | 0～67.5° |
| 4 | Angle error | ≤1° |
| 5 | Cutting speed | 0～2500m / min |
| 6 | Cutting feed rate | Adjustable |
| 7 | Working power | ～380VAC 3P+N+PE 50HZ |
| 8 | Sawing motor power | 1.5KW |
| 9 | Hydraulic station power | 0.75KW |
| 10 | Total power | 2.25KW |
| 11 | Total Weight | 884KG |
| Main use and characteristics: It is used to accurately cut plastic pipes, pipe fittings and intermediate products according to the angle in the range of 0~67.5°.Up and down travel limit, pressure abnormal alarm, automatic break protection, low voltage, low current, over current, over torque and other safety protection devices to ensure the safety of personnel and equipment; adjustable speed with variable speed, workpiece hydraulic compression; stable Good sex, low noise and easy operation. | ||
Use instructions
1. Band saw machine operation and repair personnel must undergo professional training, grasp the band sawing machine operation and repair skills. Operators should ensure adequate sleep and keep the energy focused.
2. Before you change the speed, you have to stop the machine and then open the protective cover, turn the handle to make the belt loose, place the triangle belt in the groove of the required speed, tighten the belt and cover the shield.
3. When adjusting the iron chip removing wire brushes, the wire brushes should make contact wire with the tooth of the saw blade, but not beyond the tooth root.
4. The maximum diameter of the cutting material shall not exceed the requirements and the work piece must be held firmly.
